> OK, but that would require a separate PB
> and that one WILL be "accidentially" pushed
That's why 3 buttons have to be installed on 3 sides of the box, at least 30cm (12") apart from each other, labelled "Ctrl", "Alt" and "Del", wired in series...
> No, not the Rx - you may burn your transciever, configure Tx
> as Quasi and use that one as held down at power up/reset to activate.
True, sorry.
>> "(alternatively you can enable the bootloader activation by break as
>> Andrew said earlier). "
> That requires all the funky hardware
Not at all, LPC932A1 user manual says:
The break detect can be used to reset the device and force the device into ISP mode by setting the EBRR bit (AUXR1.6)
Well, it is NOT mentioned in the ISP section, only in the UART section... (but probably all of us wrote various pieces of documentation...)
Jan Waclawek