detecting the MCU

[Maarten Stottelaar]

I'm using flashmagic a lot, most of the times I do the ISP-entry trough a manual or on board PSEN/RESET.
Sometimes Flashmagic does not detect the chip. If I use Hyperterminal to see if there is any communication it always responds to keypresses. After I've done that, Flashmagic always does detect the chip....... I've tried it on several PC's and OS's and the results are about the same. Can it have anything to do with the way flashmagic tries to connect? If hyperterminal can why can't Flashmagic.

regards,


Maarten

[Andy Ayre]

Please read the Flash Magic application note 4 - available on the Flash Magic web page. Following the steps in that document will help you and me to determine what the problem is.

regards,

[Andy Ayre]

I just uploaded version 1.75. Please give that a try also before trying the steps in Flash Magic Application Note 4. Thanks.

regards,

[caowp]

Andrew Ayre wrote:

> I just uploaded version 1.75. Please give that a try also
> before trying the steps in Flash Magic Application Note 4.
> Thanks.
>
> regards,
>
>