89C51RD2BN and Win XP

Started by David Little, October 21, 2003, 05:37:10 AM

Previous topic - Next topic

erikm

>>i have also problem in programming ...  parrallely now<<

If you can not program the chip in a qualified factory made parallel programmer there are 2 possibilities:
1) you are trying to program a 'h' chip with non-h setup or vv.
2) you have a bad chip

re 1) software releases from before the non-h chips came out may only have one setup for the Rx2 and not mention that it is 'h' setup.

Erik

Andy Ayre

WinISP does NOT support the 89C51Rx2xx fully - it only supports the 89C51Rx2Hxx family.

There is an application note on the Flash Magic web page that guides you through debugging steps. Please work through and and post more details.

Embedded Systems Academy, Inc.
support at esacademy dot com

pranita

which software support ISP  programming for 89c51RD2BN & from where I can get it?

erikm

>>which software support ISP programming for 89c51RD2BN & from where I can get it?<,

Well you found FlashMagic, what is the problem?

Erik

pranita

For the  same quotation u give me answer as follows

WinISP does NOT support the 89C51Rx2xx fully - it only supports the 89C51Rx2Hxx family.

There is an application note on the Flash Magic web page that guides you through debugging steps. Please work through and and post more details.


erikm wrote:

> >>which software support ISP programming for 89c51RD2BN & from
> where I can get it?<,
>
> Well you found FlashMagic, what is the problem?
>
> Erik

Andy Ayre

I think you might be confusing WinISP with Flash Magic. They are completely different pieces of software.

Embedded Systems Academy, Inc.
support at esacademy dot com