FLASH PROGRAMMING

Started by harnamt, October 11, 2006, 03:40:06 AM

Previous topic - Next topic

harnamt

Respected All,

I am using P89V51RD2 for making a project. The project includes the data to be written in the EEPROM of the microcontroller.

Could you please guide me how can I write in FLASH MEMORY using the FLASH MAGIC.

Is it required to invoke the BOOT LAODER for doing this.

I dont have the parallel programmer.

regards
H S Thakur

Andy Ayre

The method of placing the device into ISP mode is described in the datasheet. Basically you need to reset the device then start using Flash Magic. Flash Magic will send a stream of 'U's and ask you to reset the device.

Embedded Systems Academy, Inc.
support at esacademy dot com

Jan Waclawek

Dear H S Thakur,

If it's not you or your colleague asking there - there is a discussion on the very same topic running currently on 8052.com's forum: http://www.8052.com/forum/thread.phtml?thread=126180

Jan Waclawek