LPC2138 DK

Started by alex_k, October 23, 2006, 12:56:35 PM

Previous topic - Next topic



I'm using the IAR development kit for the LPC2138, and I'm having some problems programming the flash. Flash Magic cannot seem to connect to the processor.

P0_14 is asserted low, and reset is controlled by DTR on the UART.

Every single time I try to read or program the flash, I get the error

"Failed to read the device signature"



Andy Ayre

Are you controlling P0.14 using RTS? If not then I've never tried mixing how P0.14 and RST are controlled. Either I've used switches for both or I've used the UART signals for both.

Embedded Systems Academy, Inc.
support at esacademy dot com