Author Topic: Small bug when programming 89V51RD2  (Read 4227 times)

phonoplug

  • Jr. Member
  • **
  • Posts: 15
    • View Profile
Small bug when programming 89V51RD2
« on: January 24, 2007, 04:29:26 am »
Well I think its a bug - the first time I go to program the chip in a session, I have a message saying that security bits have been set and to confirm that I wanted this. BUT, I didnt set any! After OK'ing that I get the message about clocks bits which is correct as that box is ticked. Programming a second chip in the session does not bring up the security bits message.

I normally load FM by double clicking on a .fms settings file, and the chips are always programmed with the clocks bit set and the security bit NOT set.

Doesn't stop me programming of course, but thought I would mention it...

phonoplug

  • Jr. Member
  • **
  • Posts: 15
    • View Profile
Re: Small bug when programming 89V51RD2
« Reply #1 on: January 24, 2007, 08:00:01 am »
Ah, should have noted, this happens in version 3.20. Following an upgrade to 3.42 I can confirm it also happens in this version. Have had to go back to version 3.20 anyway. aaaah.  :-\

Andy Ayre

  • ESAcademy Staff
  • Sr. Member
  • *****
  • Posts: 2167
    • View Profile
    • Embedded Systems Academy, Inc.
    • Email
Re: Small bug when programming 89V51RD2
« Reply #2 on: January 24, 2007, 09:37:48 am »
Please email me the .fms file and the .hex file you are using so I can try to reproduce the problem here. Thanks.
Embedded Systems Academy, Inc.
support at esacademy dot com

Andy Ayre

  • ESAcademy Staff
  • Sr. Member
  • *****
  • Posts: 2167
    • View Profile
    • Embedded Systems Academy, Inc.
    • Email
Re: Small bug when programming 89V51RD2
« Reply #3 on: February 01, 2007, 01:30:09 pm »
Fixed in version 3.43, which will be released later today or tomorrow. Thanks!

Andy
Embedded Systems Academy, Inc.
support at esacademy dot com