Small bug when programming 89V51RD2

Started by phonoplug, January 24, 2007, 04:29:26 AM

Previous topic - Next topic

phonoplug

Well I think its a bug - the first time I go to program the chip in a session, I have a message saying that security bits have been set and to confirm that I wanted this. BUT, I didnt set any! After OK'ing that I get the message about clocks bits which is correct as that box is ticked. Programming a second chip in the session does not bring up the security bits message.

I normally load FM by double clicking on a .fms settings file, and the chips are always programmed with the clocks bit set and the security bit NOT set.

Doesn't stop me programming of course, but thought I would mention it...

phonoplug

Ah, should have noted, this happens in version 3.20. Following an upgrade to 3.42 I can confirm it also happens in this version. Have had to go back to version 3.20 anyway. aaaah.  :-\

Andy Ayre

Please email me the .fms file and the .hex file you are using so I can try to reproduce the problem here. Thanks.
Embedded Systems Academy, Inc.
support at esacademy dot com

Andy Ayre

Fixed in version 3.43, which will be released later today or tomorrow. Thanks!

Andy
Embedded Systems Academy, Inc.
support at esacademy dot com