Author Topic: LPC1343F Programming  (Read 7395 times)

Kele

  • Jr. Member
  • **
  • Posts: 2
    • View Profile
LPC1343F Programming
« on: April 20, 2014, 06:24:04 am »
I try connect thru ISP with usb to rs232 cable(PL2303),pins rx,tx,rts and dtr but receive error "failed to autobaud-step1".Changed various baud rates but same.Need some help what exactly pins must be connected from LPC1343FHN33 to be progammed ISP?Vcc and vss are o.k. ,3.3 volt.Try programming on board.
« Last Edit: April 22, 2014, 01:32:30 am by Andy Ayre »

Andy Ayre

  • ESAcademy Staff
  • Sr. Member
  • *****
  • Posts: 2190
    • View Profile
    • Embedded Systems Academy, Inc.
    • Email
Re: LPC1343F Programming
« Reply #1 on: April 22, 2014, 01:36:34 am »
Please start a new topic for new problems.

You need: power supply, UASRT0 tx/rx and a way of placing the device into ISP mode. That requires controlling Reset while pulling P0_1 and P0_3 to the desired logic levels. All information you need can be found in the "Flash Memory Programming" chapter of the LPC1300 user manual from NXP.

Andy
Embedded Systems Academy, Inc.
support at esacademy dot com

Kele

  • Jr. Member
  • **
  • Posts: 2
    • View Profile
Re: LPC1343F Programming
« Reply #2 on: April 23, 2014, 11:49:07 am »
Thanx Andy, will try and post results  :)

Timre10

  • Jr. Member
  • **
  • Posts: 1
    • View Profile
Re: LPC1343F Programming
« Reply #3 on: June 11, 2014, 11:46:28 am »
HI
Can I get a wiring diagram?

Andy Ayre

  • ESAcademy Staff
  • Sr. Member
  • *****
  • Posts: 2190
    • View Profile
    • Embedded Systems Academy, Inc.
    • Email
Re: LPC1343F Programming
« Reply #4 on: June 12, 2014, 01:56:25 am »
See here (click on Schematics): http://www.keil.com/mcb1000/
Embedded Systems Academy, Inc.
support at esacademy dot com