I can not Verify in LPC810

[Shoda]

It can be written in Flash Masic 8.61, but can not seem to read.

Read Device Signature >>> OK
Display Memory >>> "Unable communicate (transmit / receive)"

Hex File of writing can be, (the program to work without problems) but, long time to wait is error message appears in the Verify. >>> "Error Verifying. There is a difference in the Hex file value and the stored value. (Address 0x00000001)

I tried a combination of new chip , LPC1114, Win7, Win8.1, PL2303SA,  FT232RL it was the same result. However, in Flash Masic 7.66, I will work well.
Why. Please help me.
I'm sorry in poor English.

[Andy Ayre]

Try changing the line feed settings in the Advanced Options. Post back your results.

Andy

[Shoda]

Hi Andy.
Immediately answer Thank you.
"send Line Feed" or "expect Line Feed" the results were "Operational Failed (reading Signature)". It was the same result as until now If I enable both options.

Shoda

[Andy Ayre]

Did you try all four combinations?

[Shoda]

Hi

I tried again.

1 both options enabled
     Same to the first question.

2 Send Line Feeds is enabled.
      Read Device Signature >> "Oparation Failed (reading signature)"
      Display Memory, Programming >> "Faild to read the device signature ....... using the wrong protocol ....... device unusable. Do you     want to continue? " 　Then　"Operation Failed"

3 Expect Line Feeds is enabled.
      Read Device Signature, Display Memory, Programming >> "Unable to commmunicate. (Transmit / receive) Ensure no other ........., Try raising ..... baud rate."　

4 both options disabled
      Read Device Signature, Display Memory, Programming >> "Unable to connect to ....... (failed to autobaud-step2) Reset the hardware into ISP mode again."

Baud rate change, ISP mode setting, it has been tried, such as com port change, the result is the same.

Shoda

[Andy Ayre]

OK, please disable the line feed options (everything unchecked) so you can read the signature again.

Next generate and send me a debug file showing a signature read, erase program and verify. I assume that verify also generates the error as it is the same as reading flash.

Instructions are here: http://www.flashmagictool.com/debugfile.html

Andy

[Shoda]

I will send again.

Shoda

[Andy Ayre]

If you program a hex file (without verifying or reading it back) and reset the LPC810, does the firmware execute?

If you are unsure please create simple test firmware that toggles a pin and please give it a try.

Also please generate a debug file for the LPC1114 as well. Thanks.

Andy

[Shoda]

I　was able to program, without verifying. And　was able to execute correctly.

I'm sorry. LPC1114 is no problem. (I was wrong connection.)

Shoda

[Andy Ayre]

Please try version 8.62 and let me know if you still see a problem.

Andy

[Shoda]

Hi Andy,
I solved the problem using V8.62. In addition, LPC824 also work well.
Thank you for correspondence immediately.

Shoda