Author Topic: Slower baudrates communication (autobaud)  (Read 25040 times)

Rinin

  • Jr. Member
  • **
  • Posts: 3
    • View Profile
    • Email
Re: Slower baudrates communication (autobaud)
« Reply #30 on: August 04, 2017, 01:10:16 am »
It's FTDI based converter and it works fine with the same board and default firmware.
Even on 7812bps (9600*12/14.7456) because default 14.7456MHz oscillator was replaced with 12MHz

I understand that it's not flash magic issue, but default firmware works ok and 12MHz oscillator seems also starting.
Thats why I want to flash it with 12Mhz RedBoot and forget about onchip bootloader.

Andy Ayre

  • ESAcademy Staff
  • Sr. Member
  • *****
  • Posts: 2190
    • View Profile
    • Embedded Systems Academy, Inc.
    • Email
Re: Slower baudrates communication (autobaud)
« Reply #31 on: August 04, 2017, 03:15:52 am »
I have no idea why it can't autobaud at higher speeds. Perhaps put a scope on the Tx and Rx pins, send the '?' and see if anything looks strange. Or you could try using the high speed comms mode in Flash Magic.
Embedded Systems Academy, Inc.
support at esacademy dot com

Rinin

  • Jr. Member
  • **
  • Posts: 3
    • View Profile
    • Email
Re: Slower baudrates communication (autobaud)
« Reply #32 on: August 04, 2017, 12:55:11 pm »
Thank you, Andy for fast and professional responces, it is pleasure to meet such high level of support.

Issue was in opto-isolator of my USB-UART, it worked almost fine, but slightly affected first byte only.