Author Topic: ulink2 programming  (Read 19795 times)

nxpuser

  • Jr. Member
  • **
  • Posts: 2
    • View Profile
ulink2 programming
« on: December 10, 2017, 02:23:06 PM »
Hi,

I'm using a p89lpc952fa and a can't program it with the ulink2 from keil but a can program it by isp with the external circuit. I'm just using the TDI(pull-up), TCLK(pull-up) and RESET pin to cummunicate with the ulink2. But that tells me "no lpc95xx devide found". How can I solve this please?

Thank you.

Andy Ayre

  • ESAcademy Staff
  • Sr. Member
  • *****
  • Posts: 2190
    • View Profile
    • Embedded Systems Academy, Inc.
    • Email
Re: ulink2 programming
« Reply #1 on: December 11, 2017, 01:08:35 AM »
This forum is for Flash Magic support not ULINK.
Embedded Systems Academy, Inc.
support at esacademy dot com

nxpuser

  • Jr. Member
  • **
  • Posts: 2
    • View Profile
Re: ulink2 programming
« Reply #2 on: December 11, 2017, 06:18:35 PM »
I'm programming by ISP with flash magic. Just want the difference bitween ISP and IAP.

Andy Ayre

  • ESAcademy Staff
  • Sr. Member
  • *****
  • Posts: 2190
    • View Profile
    • Embedded Systems Academy, Inc.
    • Email
Re: ulink2 programming
« Reply #3 on: December 12, 2017, 01:28:11 AM »
ISP and IAP are very different. ISP uses the UART and an ASCII-based protocol and IAP is a lower level approach. This is described in the user manual from NXP.

Andy
Embedded Systems Academy, Inc.
support at esacademy dot com