Program NXP board LPCXpresso54628 using LPC_LINK2

Started by javiergonzalezb, March 27, 2020, 01:06:30 AM

Previous topic - Next topic

javiergonzalezb

Hello:
I'm trying to  program the LPCXpresso54628  with Flash Magic Software.
The first Time I could to program the board.
But, the next time when I wanted to program again, Flash Magic show error:

Operation failed. Failed to connect. Try disconnecting and reconnecting the board. Make sure the board appeart in the devices manager.

Andy Ayre

Is the board still shown in the drop down list in section one?

Did you program it with firmware that disabled SWD? If yes then you won't be able to reprogram it again.

Andy
Embedded Systems Academy, Inc.
support at esacademy dot com