Flash Magic Forum

In-System Programming Support => ARM Cortex => Topic started by: spybeck on November 17, 2015, 06:34:38 am

Title: LPC1227/301 Command Line issue
Post by: spybeck on November 17, 2015, 06:34:38 am
Hi Sir,

I am successfully to program NXP LPC1227/301 using Flash Magic GUI (refer to IMG_20151117_215733.jpg), but fail to program using command line (refer to IMG_20151117_220021.jpg).

Below is the command line which i type to the command Prompt, please correct me if any command wrong.

C:\Program Files\Flash Magic>FM COM(4,38400) DEVICE(LPC1227/301,11.0592) ERASE(DEVICE,PROTECTISP)  HEXFILE("C:\RE_601_COMM_02_20_07.hex",NOCHECKSUMS,FILL,PROTECTISP)  VERIFY("C:\RE_601_COMM_02_20_07.hex",NOCHECKSUMS) READCRC(DEVICE)

THANKS

Title: Re: LPC1227/301 Command Line issue
Post by: Andy Ayre on November 18, 2015, 04:19:48 pm
DEVICE directive takes three parameters - see section 8.6 in the manual.

Andy