Flash Magic Forum

In-System Programming Support => PXA-Gx9 => Topic started by: jdr on February 19, 2016, 03:01:20 PM

Title: USB-ICP-80C51ISP on a XA-G49
Post by: jdr on February 19, 2016, 03:01:20 PM
Programming an XA-G49 with a USB-ICP-80C51ISP. The scope is showing that the Reset line (at the microcontroller) is never being pulled low. The PSEN IS being pulled low. The programmer is suppose to pull the reset low... isn't it or do I have to do that? Also PIN 13 (Tx on microcontroller) is being pulled low then released. Nothing on PIN 11(Rx on microcontroller from Tx on programmer). It is failing the Device Signature.

Thanks for your time
Title: Re: USB-ICP-80C51ISP on a XA-G49
Post by: Andy Ayre on February 22, 2016, 04:20:38 AM
Yes the interface should be controlling the reset line.

Have you contacted Future Designs to see if that 8051 interface supports the XA?
Title: Re: USB-ICP-80C51ISP on a XA-G49
Post by: jdr on February 22, 2016, 07:26:41 AM
The XA-G49 is listed as a "Supported Device" for the USB-ICP-80C51ISP.
Title: Re: USB-ICP-80C51ISP on a XA-G49
Post by: Andy Ayre on February 22, 2016, 07:33:49 AM
Best bet is to contact them directly for help with their interface. From the Flash Magic point of view it is a "black box" we send ASCII commands to.

Are you working on a new development or maintaining an existing product? If maintaining what was originally used to update firmware? For new developments the XA family reached end-of-life years ago.