Messages

There is a discrepancy when we use the Windows version and the Command Line version. We are using the Keil MCB 900 programming circuitry and there is a box that is checked in the Windows Flash Magic program "Options->Advanced Options->Hardware Config->"Use DTR and RTS to enter ISP mode".

The Windows Flash Magic program pulls DTR & RTS "high" then "low" then "high" to put the chip into ISP mode. When using the Command Line interface, the DTR & RTS lines do not do this.

How is this option enabled in the Command Line interface?

Thanks

Please give a detailed description of EVERY step that the Windows Flash Magic program performs when a chip is programmed. What would be the exact same Command Line instructions?

Thanks!