Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - joange

 Hi  Andy  thanks   for   your  replay  but please   I am  still   lost .do you   have  the link  where  I  can down load   the  nxp  manual.

Hello guys,once  i programmed  Lpc 938,it refuses  reprogram it again.sometimes  I should  raise  the  value of  T1 and T2 in hardware config at flash magic situated in advanced options  to reprogram it.
could  any help.thanks