Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Nabistay

Pages: [1]
1
ARM Cortex / LPC1769 from Command Line
« on: February 23, 2011, 11:09:46 am »
Hello. I am attempting to program an LPC1769 using flash magic and the USB-ISP-LPC2k.

It works perfectly through the GUI, but through the command line, i receive the error:

ERROR: Invalid parameters for DEVICE directive: DEVICE(LPC1769,25.0000000)

this command was directly from the "Save Command Line Directives" right after a successful programming of the device through the GUI.

These are the commands from the GUI:

COM(3, 230400)
DEVICE(LPC1769, 25.000000)
INTERFACE(FDIUSBICPLPC2K)
HARDWARE(BOOTEXEC, 300, 300)
ERASEUSED(E:\Dropbox\Senior Thesis - Group\PCB Software\Test\test.hex, PROTECTISP)
HEXFILE(E:\Dropbox\Senior Thesis - Group\PCB Software\Test\test.hex, NOCHECKSUMS, NOFILL, PROTECTISP)


This is the error:


C:\Program Files (x86)\Flash Magic>FM.EXE COM(3, 230400) DEVICE(LPC1769, 25.0000
00) INTERFACE(FDIUSBICPLPC2K) HARDWARE(BOOTEXEC, 300, 300) ERASEUSED(E:\Dropbox\
Senior Thesis - Group\PCB Software\Test\test.hex, PROTECTISP) HEXFILE(E:\Dropbox
\Senior Thesis - Group\PCB Software\Test\test.hex, NOCHECKSUMS, NOFILL, PROTECTI
SP)
Flash Magic Version 5.80.2216
8051/XA Driver Version 2.78.2196
ARM UART Driver Version 2.18.2198
ARM Cortex UART Driver Version 1.45.2208
ARM Ethernet Driver Version 1.09.2196
ARM CAN Driver Version 1.09.2198
(C) Embedded Systems Academy 2000-2011 All rights reserved
NON PRODUCTION USE ONLY

ERROR: Invalid parameters for DEVICE directive: DEVICE(LPC1769,
25.000000)

Pages: [1]