LPC1343F Programming

[Kele]

I try connect thru ISP with usb to rs232 cable(PL2303),pins rx,tx,rts and dtr but receive error "failed to autobaud-step1".Changed various baud rates but same.Need some help what exactly pins must be connected from LPC1343FHN33 to be progammed ISP?Vcc and vss are o.k. ,3.3 volt.Try programming on board.

[Andy Ayre]

Please start a new topic for new problems.

You need: power supply, UASRT0 tx/rx and a way of placing the device into ISP mode. That requires controlling Reset while pulling P0_1 and P0_3 to the desired logic levels. All information you need can be found in the "Flash Memory Programming" chapter of the LPC1300 user manual from NXP.

Andy

[Kele]

Thanx Andy, will try and post results 

[Timre10]

HI
Can I get a wiring diagram?

[Andy Ayre]

See here (click on Schematics): http://www.keil.com/mcb1000/