lpc932 not working

[shridhar phadke]

89lpc 932 uc not communicating with flash magic ver 2.07.
reduce the baud rate and reset in hardware mode message given by flash magic.ihave tried to configure clock in internal rc osc mode 7.33 MHZ .ALSO TRIED FOR 12 MHZ CRYSTAL MODE SAME ERROR MESSAGE.
I HAVE TRIED BY GIVING  EXACTLY 3 PULSES ON RESET PIN 1UC ON 1UC OFF AS GIVEN IN APPLCATION NOTE BY PHILIPS( HARDWARE RESET METHOD.)
I HAVE GONE THROUGH ALL APPLICATION NOTE FOR THIS IC.
UC IS NOT READY TO OSSCILATE FOR ANY CLOCK MODE,
HOW TO START THE CLOCK OF UC 932 UNLESS IT GET CONFIUGURED
IHAVE TRIED FLASH MAGIC FOR ALL BAUD RATE 9600, 7200,2400
CAN UC START FOR ANY CLOCK OPTION  WHEN FLASH MAGIC IS NOT CONNECTED TO IT

[erikm]

UC IS NOT READY TO OSSCILATE FOR ANY CLOCK MODE,
HOW TO START THE CLOCK OF UC 932 UNLESS IT GET CONFIUGURED

Please stop SHOUTING.

If the oscillator is not running, the rest of  your questions are null and void noithing can work if the oscillator is not running.  Any controller when it comes up ( and is not defective) will have the oscillator running or nothing could work.

Two possibilities
1) permanent reset
2) defective chip

Erik