isp programming

[pradeep]

I am doing a project on Atmel t89c5115.
I have connected it to serial port of a computer through max 232. There is nothing wrong as per the connections are concerned.
I am using atmels FLIP software for ISP programming. But i am getting "Time out error" when i have tried to connect.

my pin 1.0 of the controller is pulled high by the hardware. does it cause any difference as far as the boot loader is concerned.

do i need to reset the contoller every time i try to do isp?

please help me out.

[erikm]

I am using atmels FLIP

so, you expect answers from a FlashMagic site?

Go to the flip forum (if there is one) no help here.

Erik

[pradeep]

Erik
who the hell are u!

I am trying all the possible means...