Main Menu

second Power up

Started by Julien Themont, October 10, 2003, 07:09:13 AM

Previous topic - Next topic

Julien Themont

  Hi all,

  I am currently working on a 89LPC932 version F.
  I had to turn off its power supply after it was turned on for the first time.
 No ISP cable/ ISP procedure was connected/started.
 
  Will I still be able to program it the second time, and write the break character detection prog to it ?

  Thanks

Andy Ayre

If you didn't send any ISP commands then the status bit should still be set, so when you power the device up it should enter ISP mode again.

Embedded Systems Academy, Inc.
support at esacademy dot com