LPC2103 failed to autobaud - step1

Started by Arm7, June 24, 2009, 04:12:27 AM

Previous topic - Next topic



i use Flash Magic Version 5.12.1675.

My problem is, that i get a warning " failed to autobaud - step1".

Device: LPC 2103
COM Port: 16
Baud Rate: 115200
Inteface: NONE(ISP)
Osc.:14.7456 MHz

Advaned Option
-> Hardware Config.
I  see only ISP and not the Pin (P0.14)   -> correct?  ???

Can somebody help me?


Andy Ayre

 The DTR/RTS setting depends on your hardware. Or you can place the device into ISP mode manually. Check the manual for your hardware to determine which method to use. Use a scope to check that the conditions are being met at the device pins for ISP entry.

Embedded Systems Academy, Inc.
support at esacademy dot com