Is FlashMagic 1.84 stable ?

[Jeffrey Chang]

To whom may concern,
Today, I tried using FlashMagic v1.84 instead of v1.83
for P89C61x2 under 14.318 MHz (6 clocks).
It can erase flash banks but hang on programming phase.
Therefore I switch back to v1.83 !

[Andy Ayre]

The algorithmn to send hex files was improved in 1.84. Please do the following:

1. Start Flash Magic
2. Press F1 so [Debug] appears at the top
3. Reset the device into ISP mode
3. Start programming
4. Close Flash Magic when it hangs
5. Email me (address below) the generated debug file C:\flashmagic.fmd
6. Delete C:\flashmagic.fmd

[shiue]

I try FlashMagic v1.84 for P89C61x2 under 14.318 MHz (6 clocks).
It is very well,
Can you state your setting, for example :
1. Buad Rate
2. Communication(How do you set ?)

[Jeffrey Chang]

Hi Andrew,
This morning, I tried to use FlashMagic v1.84 again
and got the same result as I described before.
Therefore I swich back again and sent the FlashMagic.fmd
and DEMO5202.fms files to you via  flashsupport@esacademy.com.

Thanks in advance !

[Andy Ayre]

I didn't receive the file. Please resend it. Thanks.