ISP with an LPC1812 not working

[robert1356]

I have received some new boards with an LPC1812 on them.  This is a custom board.  I have verified, using a terminal, that I can communicate with the ISP on the LPC1812.

Using FlashMagic, I can read the device ID and the CRP but that is the ONLY thing I can do that doesn't return an error.  When I read CRP on a brand new part (never programmed) it returns CRP Level 1 (I think it should be Level 0). 

I used a terminal to attempt to erase all flash.  This SEEMED to succeed, but when I tried reading CRP, it still showed CRP Level 1. 

Also of note, according to the NXP data sheet, the LPC1812 has only BANK A flash (15 sectors).  According to the ISP info in the LPC1812 data sheet, '0' should be used for BANK A in the 'P' and 'E' commands.  However, this returns a '7' (invalid sector).  If I use '1' I get the expected '0' return from the P and E commands.

Has anyone actually been able to successfully use FlashMagic to erase and/or program an LPC1812?  Is there a configuration file somewhere that I can try manually modifying?

I have attached a debug file from an attempt at using FlashMagic to erase the whole device.

Here is the erase sequence I executed from the terminal (the arrows are for information only):

--> ?
<-- Synchronized
--> Synchronized
<-- OK
--> 12000
<-- OK
--> U 23130
<-- 0
--> P 0 14 1
<-- 0
--> E 0 14 1
<-- 0

Thank you

[robert1356]

I'm beginning to feel pretty confident that there is an error in the LPC1812 documentation regarding Bank numbering.  I tried the following:

R 436208380 4   <-- this is address 0x1A0002FC (CRP address for BANK A)
1                        <-- Error Invalid Command
R 452985596 4   <-- this is address 0x1B0002FC (CRP address for BANK B)
0                        <-- success and the uuencoded data below is FF FF FF FF
$________
1020

[Andy Ayre]

In Flash Magic please choose the LPC1817 then activate bank B. Can you use the LPC1812 OK with those settings?

Andy