Author Topic: Can't program 8051 micro controller using Flash Magic  (Read 9408 times)

ashwin.metpalli

  • Jr. Member
  • **
  • Posts: 1
    • View Profile
    • Email
Can't program 8051 micro controller using Flash Magic
« on: March 13, 2016, 10:07:26 AM »
Hi, I am trying to program 89V51RD2 micro controller using flash magic. When it asked to reset the device into ISP mode now, I pressed the reset switch on the development board but the message box still exists and the console shows "Attempting to Connect". I am using USB to Serial port connector and the cable is perfectly OK as I have validated loop back test with it.
Could you please help me on this.

Andy Ayre

  • ESAcademy Staff
  • Sr. Member
  • *****
  • Posts: 2190
    • View Profile
    • Embedded Systems Academy, Inc.
    • Email
Re: Can't program 8051 micro controller using Flash Magic
« Reply #1 on: March 14, 2016, 04:59:24 AM »
There are lots of suggestions to debug this at http://www.flashmagictool.com/autobaud.html What have you tried and what were the results?

Andy
Embedded Systems Academy, Inc.
support at esacademy dot com