Cannot program SST89E516RD2

Started by gauravkothari23, July 08, 2017, 05:29:59 AM

Previous topic - Next topic

gauravkothari23

hi all...
i am working on a project where i have to use SMD 44 pin TQFP SST89E516RD2 microcontroller. i am using TTL converter to program this controller using RX and TX pins. but i am not able to program the controller. i am using flash magic to program. when i press start button from the software it says RESET TO ENTER ISP MODE. but when i reset the controller, nothing happens. i have checked all the connection and also the connectivity. connected RX pin to controller TX pin and TX to controller RX pin. also only TX led glows in TTL converter.
i tried changing around 4 boards but non of them are working. but the same if i try programming the DIP package, it programmes without any error.

Andy Ayre

For ST parts you will need to use an ST programming utility. Flash Magic is for NXP only.
Embedded Systems Academy, Inc.
support at esacademy dot com