Author Topic: Save Hex File - WINISP  (Read 6932 times)

RMilby

  • Jr. Member
  • **
  • Posts: 2
    • View Profile
Save Hex File - WINISP
« on: May 02, 2003, 02:01:59 pm »
I was able to set up and run WNISP, and then read the code frome the device and verify it (buffer to device). I want to save the hex file to disk, but I can't see how to do this.

It's important to save the original before I upgrade using the code given to me by the firmware people.

This, along with the display of the checksum, is an important feature in a programmer. It helps with version control and, in this case, will save me if the new code is more broken than what I have.

Rob

RMilby

  • Jr. Member
  • **
  • Posts: 2
    • View Profile
Re: Save Hex File - WINISP
« Reply #1 on: May 02, 2003, 02:13:29 pm »
duh -

the answer is "Use FlashMagic".

The (hard to find) download page on the Phillips site says "WinISP - used to program Philips FLASH ISP microcontrollers ( 89C51Rx2,  89C66x,  XA-G49)"

As I am using the XA-49, I thought this was the only tool that supports my processor.

This looks like a pretty coo tool.


Back to work!

Rob