Save Hex File - WINISP

[RMilby]

I was able to set up and run WNISP, and then read the code frome the device and verify it (buffer to device). I want to save the hex file to disk, but I can't see how to do this.

It's important to save the original before I upgrade using the code given to me by the firmware people.

This, along with the display of the checksum, is an important feature in a programmer. It helps with version control and, in this case, will save me if the new code is more broken than what I have.

[RMilby]

duh -

the answer is "Use FlashMagic".

The (hard to find) download page on the Phillips site says "WinISP - used to program Philips FLASH ISP microcontrollers ( 89C51Rx2,  89C66x,  XA-G49)"

As I am using the XA-49, I thought this was the only tool that supports my processor.

This looks like a pretty coo tool.


Back to work!