Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - muhyin

Pages: [1]
LPC9xx/LPC9xxx / ICP programming error
« on: November 08, 2010, 04:41:24 am »
Dear All,

i'm working on LPC913 and got a problem to read the device signature of my LPC913.
i got all FF, i have checked pin configuration and the pins are connected as mentioned in application note document.
when i look into RESET pin, there is no burst 7x high-low signal.

has anyone experienced with it, could somebody help me. thanks

I have followed the instruction of "In Circuit Programming (ICP) Specifications" and "AN10258 Rev. 02 21 October 2004" documents.
is it problem with supply or what?

best regards

Pages: [1]