Main Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - noelia

ARM Cortex / Re: Enabling CRP (working with IAR)
October 22, 2012, 07:00:07 AM
This is my icf file, it works with LPC1764.
Good luck!
ARM Cortex / Re: Enabling CRP (working with IAR)
February 06, 2012, 09:54:03 AM
I could program CRP OK!
I can see "CRP is at level 1" in Flash Magic. When I want to read memory says Operation Failed (reading data - security violation in device).

My startup was OK but the error was in my IAR project. It is important to configure a correct icf file in Linker Options (Options->Linker->Config->Linker Configuration File). This file has the definition for crp section.
I take LPC1768_Flash.icf from an LPC1768 example from IAR. Now I have to write one for LPC1764.
Thanks for your help.

ARM Cortex / Re: Enabling CRP (working with IAR)
February 06, 2012, 05:27:46 AM
When I go to ISP->Display Memory-> 000002F0
I see this:
00 88 36 30 DF F8 08 1B 08 80 DF F8 34 09 00 78

I was testing with different values in my startup (0x87654321, 0x12345678 and 0xFFFFFFFF) and I always read the same.

This is the line in my hex file:
:1002F000 00883630DFF8081B0880DFF834090078 02

Am I looking the value (0x87654321) in the correct line?
My code is already protected? or not?

ARM Cortex / Enabling CRP (working with IAR)
February 03, 2012, 06:24:31 AM
I am working with LPC1764 and IAR compiler. I am trying to enable CRP in my code but I can't. Flash Magic always say to me "CRP is disabled" (I tried with two different boards and always test it through a power cycle).

I tried two options:
1) Writing this code in main, but it doesn't work because is for KEIL

const unsigned long crp __attribute__ ((at(0x2FC))) = 0x87654321;

2) Adding this to startup_LPC17xx.s after Default interrupt handlers and before END. I attached the file.

DCD 0x87654321

Flash Magic works perfectly, I can read memory, erase, program, etc. But I can't protect my board.
I read the UM10360 and AN10851.
What am I doing wrong?