Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - gjimenez

#1
ARM Cortex / Re: MAC OS Settings
August 07, 2015, 03:56:54 PM
Yes, I selected  LPC1115/303
#2
ARM Cortex / Re: MAC OS Settings
August 07, 2015, 12:51:52 PM
Hello Andy,

This is what I see in terms of available COM ports:
lrwxr-xr-x  1 gjimenezdorigo  admin  24 Aug  7 15:32 COM10 -> /dev/tty.Bluetooth-Modem
lrwxr-xr-x  1 gjimenezdorigo  admin  23 Aug  7 15:32 COM11 -> /dev/tty.EV3-SerialPort
lrwxr-xr-x  1 gjimenezdorigo  admin  32 Aug  7 15:32 COM12 -> /dev/tty.GiovanniJimenezsiPod-Wi
lrwxr-xr-x  1 gjimenezdorigo  admin  23 Aug  7 15:32 COM13 -> /dev/tty.SLAB_USBtoUART
lrwxr-xr-x  1 gjimenezdorigo  admin  31 Aug  7 15:32 COM4 -> /dev/cu.Bluetooth-Incoming-Port
lrwxr-xr-x  1 gjimenezdorigo  admin  23 Aug  7 15:32 COM5 -> /dev/cu.Bluetooth-Modem
lrwxr-xr-x  1 gjimenezdorigo  admin  22 Aug  7 15:32 COM6 -> /dev/cu.EV3-SerialPort
lrwxr-xr-x  1 gjimenezdorigo  admin  31 Aug  7 15:32 COM7 -> /dev/cu.GiovanniJimenezsiPod-Wi
lrwxr-xr-x  1 gjimenezdorigo  admin  22 Aug  7 15:32 COM8 -> /dev/cu.SLAB_USBtoUART
lrwxr-xr-x  1 gjimenezdorigo  admin  32 Aug  7 15:32 COM9 -> /dev/tty.Bluetooth-Incoming-Port

So I assume I should use either Com 8 or COM 13

When I use COM 13, I get the "Failed to Autobaud - step 1" error msg.  I went to the forum page but cannot figure out what I need to do to make the connection. The calculator I am trying to connect is new, and the cable (micro USB - USB) is new as well, so I doubt the issue is with the calc or the cable

Thanks !

#3
ARM Cortex / Re: MAC OS Settings
August 06, 2015, 02:54:47 PM
Thank you Andy.  The CPU on the "device"  (a calculator) is the LPC1115

Giovanni
#4
ARM Cortex / MAC OS Settings
August 05, 2015, 06:08:22 PM
I am trying to Firmware flash a device (a calculator) connected to my Mac Mini (OS Yosemite), on a USB port, but I am not being able to connect to this device

I don't know what COM Port to use, or what baud rate

Thank you for your help !