Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - gates2231

#1
General Discussion / Basics
July 01, 2007, 10:11:08 PM
Hello
my name is chinni krishna
i am a +2 student going for engineering in ECE stream
i am using a P89V51RD2 MCU on a board bought frm TRI Techno solutions
i am a good programmer of C and C++

my problem is i am not able to understand anything about microprocessors
i don't know where to start
so plz kindly suggest me good books tat makes me understand micros fully and tat can get me into the position of implementing my own circuit boards
plz help meeeeeeeeeeeeeee
#2
hello
i am using P89V51RD2.It used to work fine until i connceted to PC.i used flash magic.one day i cliked on device configuration and simply cliked on RUN USER CODE.It showed a warning tat flashmagic won't be able to  communicate with it the micro if i do it.but out of curiosity i did so and the next time wen i want to burn a program it is showing the message."RESET THE DEVICE INTO ISP MODE NOW".I am actually using this chip on a board made by TRI called iBoard.IT has onboard 555 timer IC for resetting the board.But even i press that button it is not working.so wat i did is i got a new mcu and replaced the old one and it is working fine but again due to my curiosity i did the same thing and lost tat one also.now plz kindly tell me how to bring the MCU back to ISP mode ASAP.i am +2 student and knows only programming nothing abt electioncs except soldering and reading circuits etc...
plz help me out