Main Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - an17

hi yes i mean the hyperterminal test.Since i posted this i was able to send a upper case U in hyperterminal. Then have it echoed back at a baud of 2400 with a clock speed of 10mhz. But i am still un able to connect in flash magic using any of the baud rates. any ideas
hi guys i was hoping someone might be able to help me i have built a isp programmer for a p89c51rc2bn using the same circuit in an461 but only diffrences is i have tied p2.6 p2.7 to vcc through 10k resistors and for a reset circuit i am using a ds1223 reset assistant but it won't write to read the chip i have tried the terminal test sending a U i have checked if it transmitts and recieves the U which it does but flashmagic says that it can not communicate recieve or transmitt makesure nothing is using the port and in the terminal in flashmagic if i send a U i get a strange looking f so if anyone can help me i would be greatful
Old Topics / crystal oscillator
October 31, 2004, 11:00:24 PM
hi guys i was hoping one of you guys might  be able to tell if i measure with my  oscilloscope on one of the xtal pins of my micro should i see a sinewave of some sort because i am not sure if my crystal oscillator is working
Old Topics / Re: p89c51rd2hba
October 19, 2004, 04:53:53 PM
where can i get the errata sheet
Old Topics / p89c51rd2hba
October 19, 2004, 01:27:39 AM
hi guys i am hoping someone could help me i have made myself programmer. It is for a p89c51rd2hba chip but i can't get it to connect in flash magic. It doesn't connect at any board rate. My setup is as follows it has a 10mhz crystal, i have vpp going to vcc 5 reset going to ground via a o.1uf capacitor and psen is going to ground  p2.7 is going to 5 volts i am using a max232 which is connected to tx and rx.Ale is connectd to 5 volts
if any one could give me some help i would greatful