Support in ISP for LPC1765 Using flash magic

[samson.bunty]

Hi Everyone,

Am new to this,Am using NXP LPC1765 controller,am doing insist programinng using flash magic. But i had a problem in that. After programming the controller is not booting(not going to user application mode). I have disabled the isp pin once i finished the programing. I have checked with Scope the Tx & Rx pins of the controller. the data is transfering. Both pins Tx & Rx are working fine. Kindly suggest me what will be the problem here? Will it be Software Issue or Hardware Issue??

Thanks in advance

Regards,
Samson 

[Andy Ayre]

If it is not executing your firmware does that mean the bootloader is still executing?

Andy