Author Topic: Support in ISP for LPC1765 Using flash magic  (Read 4450 times)

samson.bunty

  • Jr. Member
  • **
  • Posts: 1
    • View Profile
    • Email
Support in ISP for LPC1765 Using flash magic
« on: November 03, 2012, 09:53:28 am »
Hi Everyone,

Am new to this,Am using NXP LPC1765 controller,am doing insist programinng using flash magic. But i had a problem in that. After programming the controller is not booting(not going to user application mode). I have disabled the isp pin once i finished the programing. I have checked with Scope the Tx & Rx pins of the controller. the data is transfering. Both pins Tx & Rx are working fine. Kindly suggest me what will be the problem here? Will it be Software Issue or Hardware Issue??

Thanks in advance

Regards,
Samson 

Andy Ayre

  • ESAcademy Staff
  • Sr. Member
  • *****
  • Posts: 2190
    • View Profile
    • Embedded Systems Academy, Inc.
    • Email
Re: Support in ISP for LPC1765 Using flash magic
« Reply #1 on: November 05, 2012, 12:34:23 am »
If it is not executing your firmware does that mean the bootloader is still executing?

Andy
Embedded Systems Academy, Inc.
support at esacademy dot com