lpc1857 does not start after program with flash magic

[lalitshah233]

Hi all,

I am new to NXP.

I have purchased MCB1800 development kit and using keil ide to compile the sample blinky code provided for this board with keil ide.

I have used flash configuration to program this code into internal flash memory of the LPC1857.

I have downloaded this code with the help of UART0 and flash magic.

I am not able to see program running.

For verification i have look at the data in flash memory with the help of flash magic and have found that it stores image.

Do i miss any settings on MCB1800 board or anythins is required from flash magic side to make it work.
Regards,
Lalit Shah

[Andy Ayre]

Check/tick "Activate Flash Bank" in section 4 of the main window before clicking on "Start".

Andy