Author Topic: lpc1857 does not start after program with flash magic  (Read 4911 times)

lalitshah233

  • Jr. Member
  • **
  • Posts: 1
    • View Profile
    • Email
lpc1857 does not start after program with flash magic
« on: December 13, 2012, 02:19:00 am »
Hi all,

I am new to NXP.

I have purchased MCB1800 development kit and using keil ide to compile the sample blinky code provided for this board with keil ide.

I have used flash configuration to program this code into internal flash memory of the LPC1857.

I have downloaded this code with the help of UART0 and flash magic.

I am not able to see program running.

For verification i have look at the data in flash memory with the help of flash magic and have found that it stores image.

Do i miss any settings on MCB1800 board or anythins is required from flash magic side to make it work.
Regards,
Lalit Shah

Andy Ayre

  • ESAcademy Staff
  • Sr. Member
  • *****
  • Posts: 2190
    • View Profile
    • Embedded Systems Academy, Inc.
    • Email
Re: lpc1857 does not start after program with flash magic
« Reply #1 on: December 14, 2012, 01:14:48 am »
Check/tick "Activate Flash Bank" in section 4 of the main window before clicking on "Start".

Andy
Embedded Systems Academy, Inc.
support at esacademy dot com