Problem with USB(FTDI FT232BL)

[kezlok]

Hi
I am writing because, I need latest version Flash Magic eg. 4.35m. I have problem with my LPC2148. I don't connect by USB my test board. I Always give this same error "Failed To Autobaud". Computer detect device- Serial port and USB serial  Converter(chip USB<=>UART is FTDI FT232BL ) but I don't have a communication with uC.

[Andy Ayre]

4.35 isn't the latest version.

Depending on which USB port you used the COM port number can change. Check in the device manager the COM port number by disconnected and reconnecting the cable while watching the hardware list.

Also see: http://www.flashmagictool.com/autobaud.html

Andy