Author Topic: USB-ICP-80C51ISP on a XA-G49  (Read 7398 times)

jdr

  • Jr. Member
  • **
  • Posts: 12
    • View Profile
    • Email
USB-ICP-80C51ISP on a XA-G49
« on: February 19, 2016, 03:01:20 PM »
Programming an XA-G49 with a USB-ICP-80C51ISP. The scope is showing that the Reset line (at the microcontroller) is never being pulled low. The PSEN IS being pulled low. The programmer is suppose to pull the reset low... isn't it or do I have to do that? Also PIN 13 (Tx on microcontroller) is being pulled low then released. Nothing on PIN 11(Rx on microcontroller from Tx on programmer). It is failing the Device Signature.

Thanks for your time

Andy Ayre

  • ESAcademy Staff
  • Sr. Member
  • *****
  • Posts: 2190
    • View Profile
    • Embedded Systems Academy, Inc.
    • Email
Re: USB-ICP-80C51ISP on a XA-G49
« Reply #1 on: February 22, 2016, 04:20:38 AM »
Yes the interface should be controlling the reset line.

Have you contacted Future Designs to see if that 8051 interface supports the XA?
Embedded Systems Academy, Inc.
support at esacademy dot com

jdr

  • Jr. Member
  • **
  • Posts: 12
    • View Profile
    • Email
Re: USB-ICP-80C51ISP on a XA-G49
« Reply #2 on: February 22, 2016, 07:26:41 AM »
The XA-G49 is listed as a "Supported Device" for the USB-ICP-80C51ISP.

Andy Ayre

  • ESAcademy Staff
  • Sr. Member
  • *****
  • Posts: 2190
    • View Profile
    • Embedded Systems Academy, Inc.
    • Email
Re: USB-ICP-80C51ISP on a XA-G49
« Reply #3 on: February 22, 2016, 07:33:49 AM »
Best bet is to contact them directly for help with their interface. From the Flash Magic point of view it is a "black box" we send ASCII commands to.

Are you working on a new development or maintaining an existing product? If maintaining what was originally used to update firmware? For new developments the XA family reached end-of-life years ago.

Embedded Systems Academy, Inc.
support at esacademy dot com