Author Topic: Program NXP board LPCXpresso54628 using LPC_LINK2  (Read 594 times)

javiergonzalezb

  • Jr. Member
  • **
  • Posts: 1
    • View Profile
Program NXP board LPCXpresso54628 using LPC_LINK2
« on: March 27, 2020, 01:06:30 am »
Hello:
I'm trying to  program the LPCXpresso54628  with Flash Magic Software.
The first Time I could to program the board.
But, the next time when I wanted to program again, Flash Magic show error:

Operation failed. Failed to connect. Try disconnecting and reconnecting the board. Make sure the board appeart in the devices manager.

Andy Ayre

  • ESAcademy Staff
  • Sr. Member
  • *****
  • Posts: 2168
    • View Profile
    • Embedded Systems Academy, Inc.
    • Email
Re: Program NXP board LPCXpresso54628 using LPC_LINK2
« Reply #1 on: March 27, 2020, 08:55:03 am »
Is the board still shown in the drop down list in section one?

Did you program it with firmware that disabled SWD? If yes then you won't be able to reprogram it again.

Andy
Embedded Systems Academy, Inc.
support at esacademy dot com