Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - da_migel

Pages: [1]
General Discussion / Re: Silent Instal FlashMagicProdSys
« on: January 23, 2018, 01:09:18 am »
Hello Andy,

with some installers u can either tell them where a license file is located, save it in a config-file where other information are stored aswell or using a switch like --acceptlicense

However, i am pretty sure the license agreement can be disabled with a switch already (/SUPPRESSMSGBOXES should do it imo)

General Discussion / Silent Instal FlashMagicProdSys
« on: January 22, 2018, 01:53:25 am »

i need to install Flash Magic Production System in silent mode. I already found the command line switches and the official documentation / help of command line arguments.

However, i get the following Dialog:
'The activation code is not valid for this product. Please contact the vendor where you purchased this product'

If i install the setup manually and enter my activation code everything works fine. I already tried to get that information i the setup-config file with /SAVEINF= and /LOADINF=

Is there a way passing the registration code to the installer?

Thanks for help,

Pages: [1]